High Speed Disperser is a kind of switching valve in a broad sense. Because the fast stirring device (such as the circular sawtooth stirring device) can produce strong flow in some areas, it generally has a strong dispersing and chemical effect on the raw materials. So such a high-speed mixer is also called a disperser.

The paint high-speed disperser uses a fast stirring device (such as a circular sawtooth stirring device) and can also produce a strong flow field in some areas, which generally has a strong dispersing emulsion effect on the raw materials. Nowadays, the use of paint high-speed dispersers has become more and more common. Do you know what to pay attention to when buying a paint disperser? Come and take a look with the editor!

The purpose of the motor brand is to determine the quality of the motor. For the paint disperser, the motor is a large object and a key component to measure the quality of the paint disperser. It cannot be cheated by the merchant.

The brand of the variable frequency speed regulator

Generally speaking, the paint high-speed disperser must be equipped with a variable frequency speed regulator. Since the speed ratio of the paint disperser is not fixed, it should be adjusted in time according to the specific situation and process purpose. The frequency converter is very important for the paint dispersing machine. If you are not careful or buy a cheap frequency converter, it will break down after a period of use.

Types of hydraulic cylinders

General users do not know that the configuration of the paint dispersing machine mainly includes two types of hydraulic cylinders, one is the engineering cylinder and the other is the earth hydraulic cylinder (the sealing design and sealing element are the hydraulic cylinders with fillers). The engineering cylinder has stable operation and stable quality, so our company's hydraulic lifting rapid paint dispersing machine uses this type of hydraulic cylinder; the earth hydraulic cylinder equipment has a high failure rate and is very easy to leak oil.

Material of mixing and dispersing shaft

From the perspective of the mixing shaft of the carbon steel electroplating process, there are still corrosion problems and the electroplating layer is not wear-resistant. Once this problem occurs, it also means that you must buy another shaft for repair, which delays things and does not achieve the actual effect of cost-effectiveness.

Bearing configuration in the agitator shaft

In the industry, there are two bearings and three bearings. The lower bearing of the two-bearing one is not durable, while the three-bearing one has significantly improved tolerance due to the two bearings placed at the bottom, and the equipment failure rate is low; in terms of bearing quality, there are general bearings and well-known brand bearings. The general bearings have a short service life and a high equipment failure rate.