Sanitary Pump Installation preparation
Please check that the following points must be met:
1. Whether the power supply marked on the motor nameplate is consistent with the on-site power supply;
2. Whether the drive device is intact (whether it is damaged during transportation or storage);
3. Whether the stainless steel sanitary pump meets special environmental conditions (whether it is flammable and explosive, whether it is acidic and corrosive).
Installation location:
The foundation of the stainless steel sanitary pump should generally be a flat ground with sufficient strength;
The pump unit should be installed at the lowest position of the equipment as much as possible, that is, the position with the maximum head height;
Pipeline installation
The diameter of the pipeline should be consistent with the inlet and outlet diameters of the pump, and the inlet diameter cannot be too small. (When the diameter of the pipeline is smaller than the diameter of the pump, use an eccentric reducer to adjust the small-diameter pipeline as much as possible to shorten the small-diameter pipeline to avoid forming a gas trap.) The outlet diameter cannot be too large. When the outlet diameter is larger than the pump outlet, try to extend the distance from the pump outlet to avoid overloading the pump motor.
System monitoring device:
A valve and a pressure gauge should be installed near the inlet and outlet of the pump to adjust the flow and monitor the operating status of the pump. If necessary, a flow meter can be installed on the system pipeline.
Power connection
When checking that the parameters of the power supply and the motor are consistent, connect the wires according to the wiring method on the motor junction box
The power supply must have protective switches such as air switches and thermal relays
The motor must be connected to the ground wire