Emulsification Pump is also a common device, and its role is also quite large. It also brings many advantages when it is used. But no matter what, you must master its correct method before operating it. Let's make a brief introduction for everyone below. If you are interested, you may wish to take a look.

After you buy the emulsifier, you must first read its instructions, and you must master the method when operating it. First, turn on the main switch of the emulsifier. At this time, its machine display panel is in the Service-position position, and then open the discharge door. The next thing you have to do is to install the knife, screen plate and sleeve in order. After these are assembled, you can then close the emulsifier discharge door and clamp it, and the two display points must be flush when it is installed. In addition, when we operate the emulsifier, we also need to know that when pressing the "--" key on the operation panel, the machine will automatically detect the operating status, and the display panel will display Initialrun. When the display appears, you cannot touch any operation key. If the display panel of the emulsifier shows Standy-position, then you can put the raw materials into the hopper. In this case, you just need to press the "I" key to start the machine. There are some things to note here. For example, when there is no raw material in the hopper, press the "0" key to stop the machine. Then when there is no raw material inside, the machine cannot be started at this time, otherwise the knife and screen will be damaged.

What is said here are the correct operation methods of the emulsifier. Each process is also very important. I hope users will pay more attention. After all the above are done, the next thing you need to know is that when the emulsifier is finished, press the function key ￡ once, then its display panel will display cleaning-position. At this time, you can inject clean water into the hopper and press the "I" key to knock out the excess raw materials in the pipe. After opening, you can press the function key "￡" again. When the display panel of the emulsifier shows service-position, you can open the discharge door, and then remove the discharge pipe, knife, screen and sleeve, etc., and turn off the main power. In addition, we also need to know here that the emulsifier still needs to be cleaned, wipe the surface dry, and add lubricating oil. Only by doing these can you extend its service life, otherwise it will be shortened. When using it, you should also pay attention to the fact that if there is abnormal noise during the operation of the emulsifier, you should stop the machine immediately and notify the maintenance personnel. You must not force the operation. If you don’t understand something, you can call us at any time.

The above article is the editor’s way to use the emulsifier correctly. I don’t know if you have learned it. If you have this need, come and have a look, it will definitely not let you down. Welcome to come here to choose the equipment that suits you.